In this project we will get the current altitude and temperature using an MPL3115A2 pressure sensor connected to an LCD keypad shield fitted to an Arduino Uno Here is a little information regarding the sensor. The MPL3115A2 is a compact, piezoresistive, …
Tag:
Temperature
-
-
In this example we will display temperature readings from a TMP175 sensor on a Nokia LCD4884 shield The TMP75 and TMP175 devices are digital temperature sensors ideal for NTC and PTC thermistor replacement. The devices offer a typical accuracy of …
-
The Si7021 I2C Humidity and Temperature Sensor is a monolithic CMOS IC integrating humidity and temperature sensor elements, an analog-to-digital converter, signal processing, calibration data, and an I2C Interface. The patented use of industry-standard, low-K polymeric dielectrics for sensing humidity …
-
In this example we will connect an LM35 temperature sensor to our Arduino The LM35 series are precision integrated-circuit temperature sensors, whose output voltage is linearly proportional to the Celsius (Centigrade) temperature. The LM35 thus has an advantage over linear …
-
The MCP9808 digital temperature sensor converts temperatures between -20°C and +100°C to a digital word with ±0.5°C (max.) accuracy. The MCP9808 comes with user-programmable registers that provide flexibility for temperature sensing applications. The registers allow user-selectable settings such as Shutdown …
-
SHT31 is the next generation of Sensirion’s temperature and humidity sensors. It builds on a new CMOSens® sensor chip that is at the heart of Sensirion’s new humidity and temperatureplatform. The SHT3x-DIS has increased intelligence, reliability and improved accuracy specifications compared …
-
In this example we use the DHT22 (or AM2302) humidity/temperature sensor and the Arduino UNO board to read data and print it out to the serial monitor. The DHT22 is better than the DHT11 because it has a wider range of measurement, …
-
In this example we connect a DHT11 sensor our Arduino, again we will display the temperature and this time the humidity as well on our LCD4884 shield. In this example we connected the data pin of the DHT11 to Pin …
-
In this example we will show a basic example of connecting a DHT11 Temperature and Humidity Sensor to your Arduino. This is a very nice little, low cost sensor which requires only a pull up resistor to VDD. This can …